Mining Machinery

Hex Head Cone Neck Bolt.

drawing · Grade 8 · 1-1/4-12 UNF × 56 (designation as supplied)

Hex Head Cone Neck Bolt for mining coal haulers. Review the product reference, recorded specifications and drawing requirements to identify the configuration needed for your assembly.

Catalogue reference: CF-MI-010

Grade / hardnessGrade 8
Size / designationSee parameters
Surface treatmentSee parameters
Standard / drawingdrawing
Request a quote

Parameters

Technical parameters.

Product technical parameters
ProductHex Head Cone Neck Bolt
Standard / drawingdrawing
Grade / hardnessGrade 8
Size / designation1-1/4-12 UNF × 56 (designation as supplied)
Surface treatmentZinc-aluminium coating (FLZ) or custom finish
Friction coefficient (µ total)0.11–0.18
ApplicationMining coal haulers
Application recordRecorded since 2013

Confirm the final specification against the order drawing. A recorded application year is not a service-life or warranty statement.

  • The meaning and unit of '56' are not defined in this source record. Confirm them against the drawing before ordering.
  • The photograph is the shared coal-hauler fastener group from the source catalogue, not an individual dimensional illustration of this item.

Product details

Product description.

Fasteners for mining coal haulers.

The recorded application is mining coal haulers. This entry is one item in the coal-hauler fastening group, which includes separate bolt, stud, nut and washer records. Use the individual product designation and assembly drawing when requesting a replacement; the shared group photograph does not establish the dimensions of this item.

Mining coal haulers

Design basis

This is a drawing-defined or non-standard configuration. Start with the product name and catalogue reference, then provide the current drawing revision and the exact version required. The parameter table records the supplied specification; dimensions, material designation and acceptance requirements that are not stated there should be confirmed before quotation.

Drawing and part reference

Head, shank & thread

Identify the head form, thread designation, overall or under-head length and any fitted-shank or shoulder details from the drawing. Where the product name specifies a flange, drilled hole, special drive or cone neck, include that feature in the part reference. A similar photograph is not enough to establish the same specification.

Configuration to confirm

Finish & assembly conditions

The listed treatment is Zinc-aluminium coating (FLZ) or custom finish. Specify which listed option is required, together with any drawing-defined preparation or inspection requirements. The recorded friction requirement should remain linked to that specification; it is not an installation-torque value. Tightening instructions and acceptance conditions need confirmation for the actual assembly.

Project-specific requirements

Selection guide.

A clear drawing and complete inquiry help distinguish the exact part from another fastener in the same application group.

  • Part reference

    Send the drawing number and revision, or identify the existing component.

  • Dimensions

    Thread, pitch, length and mating dimensions. Mark any special geometry on the drawing.

  • Grade / hardness

    Identify the required listed option and retain its original grade or hardness notation.

  • Surface requirements

    State the required finish and any project-specific friction or inspection requirements.

  • Order scope

    Specify quantity, additional components and your requested delivery date.

Quote catalogue reference CF-MI-010 when contacting us. Related products below are separate catalogue entries, not a pre-approved assembly kit. Please confirm mating parts and final requirements against the assembly drawing.

Discuss your drawing

Start a Project

Bring us the drawing, specification or operating problem.

Share the application, quantity, material, grade, finish, drawing and delivery target. We will use those details to frame the next technical conversation.

RFQ