Reference photograph from the supplied product record. Confirm exact dimensions against the drawing.
Mining Machinery
Stud — Mining Record 1.
Drawing · 8.8 or 10.9 · M24–M90 × L
Stud — Mining Record 1 for mining machinery. Review the product reference, recorded specifications and drawing requirements to identify the configuration needed for your assembly.
Catalogue reference: CF-MI-001
Parameters
Technical parameters.
| Product | Stud — Mining Record 1 |
|---|---|
| Standard / drawing | Drawing |
| Grade / hardness | 8.8 or 10.9 |
| Size / designation | M24–M90 × L |
| Surface treatment | Black oxide |
| Friction coefficient (µ total) | 0.15–0.18 |
| Application | Mining machinery |
| Application record | Recorded since 2015 |
Confirm the final specification against the order drawing. A recorded application year is not a service-life or warranty statement.
Product details
Product description.
Fasteners for mining equipment.
This product belongs to the mining machinery catalogue. Keep its individual part reference linked to the relevant equipment drawing when planning a replacement or a new assembly. The recorded product designation and thread system should be checked before comparing it with another mining fastener.
Design basis
This is a drawing-defined or non-standard configuration. Start with the product name and catalogue reference, then provide the current drawing revision and the exact version required. The parameter table records the supplied specification; dimensions, material designation and acceptance requirements that are not stated there should be confirmed before quotation.
Drawing and part referenceThreaded ends & length
Provide the overall length, thread designation and required threaded length at each end, together with any plain-shank or shoulder dimensions. If the catalogue uses L, specify the actual length in the drawing. Keep each stud reference separate even when several entries share the same listed diameter range and grade options.
Configuration to confirmFinish & assembly conditions
The listed treatment is Black oxide. Specify which listed option is required, together with any drawing-defined preparation or inspection requirements. The recorded friction requirement should remain linked to that specification; it is not an installation-torque value. Tightening instructions and acceptance conditions need confirmation for the actual assembly.
Project-specific requirementsSelection guide.
A clear drawing and complete inquiry help distinguish the exact part from another fastener in the same application group.
Part reference
Send the drawing number and revision, or identify the existing component.
Dimensions
Thread, pitch, length and mating dimensions. Mark any special geometry on the drawing.
Grade / hardness
Identify the required listed option and retain its original grade or hardness notation.
Surface requirements
State the required finish and any project-specific friction or inspection requirements.
Order scope
Specify quantity, additional components and your requested delivery date.
Quote catalogue reference CF-MI-001 when contacting us. Related products below are separate catalogue entries, not a pre-approved assembly kit. Please confirm mating parts and final requirements against the assembly drawing.
Discuss your drawing






