Mining Machinery

Stud — Mining Record 2.

Drawing · 8.8 or 10.9 · M24–M90 × L

Stud — Mining Record 2 for mining machinery. Review the product reference, recorded specifications and drawing requirements to identify the configuration needed for your assembly.

Catalogue reference: CF-MI-001-R060

Grade / hardness8.8 or 10.9
Size / designationM24–M90 × L
Surface treatmentBlack oxide
Standard / drawingDrawing
Request a quote

Parameters

Technical parameters.

Product technical parameters
ProductStud — Mining Record 2
Standard / drawingDrawing
Grade / hardness8.8 or 10.9
Size / designationM24–M90 × L
Surface treatmentBlack oxide
Friction coefficient (µ total)0.15–0.18
ApplicationMining machinery
Application recordRecorded since 2015

Confirm the final specification against the order drawing. A recorded application year is not a service-life or warranty statement.

Product details

Product description.

Fasteners for mining equipment.

This product belongs to the mining machinery catalogue. Keep its individual part reference linked to the relevant equipment drawing when planning a replacement or a new assembly. The recorded product designation and thread system should be checked before comparing it with another mining fastener.

Mining machinery

Design basis

This is a drawing-defined or non-standard configuration. Start with the product name and catalogue reference, then provide the current drawing revision and the exact version required. The parameter table records the supplied specification; dimensions, material designation and acceptance requirements that are not stated there should be confirmed before quotation.

Drawing and part reference

Threaded ends & length

Provide the overall length, thread designation and required threaded length at each end, together with any plain-shank or shoulder dimensions. If the catalogue uses L, specify the actual length in the drawing. Keep each stud reference separate even when several entries share the same listed diameter range and grade options.

Configuration to confirm

Finish & assembly conditions

The listed treatment is Black oxide. Specify which listed option is required, together with any drawing-defined preparation or inspection requirements. The recorded friction requirement should remain linked to that specification; it is not an installation-torque value. Tightening instructions and acceptance conditions need confirmation for the actual assembly.

Project-specific requirements

Selection guide.

A clear drawing and complete inquiry help distinguish the exact part from another fastener in the same application group.

  • Part reference

    Send the drawing number and revision, or identify the existing component.

  • Dimensions

    Thread, pitch, length and mating dimensions. Mark any special geometry on the drawing.

  • Grade / hardness

    Identify the required listed option and retain its original grade or hardness notation.

  • Surface requirements

    State the required finish and any project-specific friction or inspection requirements.

  • Order scope

    Specify quantity, additional components and your requested delivery date.

Quote catalogue reference CF-MI-001-R060 when contacting us. Related products below are separate catalogue entries, not a pre-approved assembly kit. Please confirm mating parts and final requirements against the assembly drawing.

Discuss your drawing

Start a Project

Bring us the drawing, specification or operating problem.

Share the application, quantity, material, grade, finish, drawing and delivery target. We will use those details to frame the next technical conversation.

RFQ