Reference photograph from the supplied product record. Confirm exact dimensions against the drawing.
Marine & Offshore
Marine Stud Bolt.
DIN 938 or DIN 939 · 10.9 · M16–M90
Marine Stud Bolt for marine and offshore cranes. Review the product reference, recorded specifications and drawing requirements to identify the configuration needed for your assembly.
Catalogue reference: CF-MO-003
Parameters
Technical parameters.
| Product | Marine Stud Bolt |
|---|---|
| Standard / drawing | DIN 938 or DIN 939 |
| Grade / hardness | 10.9 |
| Size / designation | M16–M90 |
| Surface treatment | Black oxide |
| Friction coefficient (µ total) | 0.11–0.18 |
| Application | Marine and offshore cranes |
| Application record | Recorded since 2012 |
Confirm the final specification against the order drawing. A recorded application year is not a service-life or warranty statement.
Product details
Product description.
Marine equipment fastening.
This product is part of the marine and offshore fastening catalogue. Identify the relevant equipment and assembly position in your inquiry, then confirm the dimensions and mating components from the drawing. The application category alone does not specify a corrosion-test duration, service life or marine certification.
Design basis
The product record cites DIN 938 or DIN 939. Include that standard designation and the relevant drawing revision in your inquiry, and identify any order-specific differences. The standard reference does not replace the need to confirm the listed size, required grade and finish. Requirements not stated in this product record should remain subject to drawing confirmation.
Drawing and part referenceThreaded ends & length
Provide the overall length, thread designation and required threaded length at each end, together with any plain-shank or shoulder dimensions. If the catalogue uses L, specify the actual length in the drawing. Keep each stud reference separate even when several entries share the same listed diameter range and grade options.
Configuration to confirmFinish & assembly conditions
The listed treatment is Black oxide. Specify which listed option is required, together with any drawing-defined preparation or inspection requirements. The recorded friction requirement should remain linked to that specification; it is not an installation-torque value. Tightening instructions and acceptance conditions need confirmation for the actual assembly.
Project-specific requirementsSelection guide.
A clear drawing and complete inquiry help distinguish the exact part from another fastener in the same application group.
Part reference
Send the drawing number and revision, or identify the existing component.
Dimensions
Thread, pitch, length and mating dimensions. Mark any special geometry on the drawing.
Grade / hardness
Identify the required listed option and retain its original grade or hardness notation.
Surface requirements
State the required finish and any project-specific friction or inspection requirements.
Order scope
Specify quantity, additional components and your requested delivery date.
Quote catalogue reference CF-MO-003 when contacting us. Related products below are separate catalogue entries, not a pre-approved assembly kit. Please confirm mating parts and final requirements against the assembly drawing.
Discuss your drawing






