Marine & Offshore

Marine Washer.

DIN 6916 · HV300 Min · M16–M140

Marine Washer for marine equipment. Review the product reference, recorded specifications and drawing requirements to identify the configuration needed for your assembly.

Catalogue reference: CF-MO-005

Grade / hardnessHV300 Min
Size / designationM16–M140
Surface treatmentBlack oxide
Standard / drawingDIN 6916
Request a quote

Parameters

Technical parameters.

Product technical parameters
ProductMarine Washer
Standard / drawingDIN 6916
Grade / hardnessHV300 Min
Size / designationM16–M140
Surface treatmentBlack oxide
Friction coefficient (µ total)0.11–0.18
ApplicationMarine equipment
Application recordRecorded since 2012

Confirm the final specification against the order drawing. A recorded application year is not a service-life or warranty statement.

Product details

Product description.

Marine equipment fastening.

This product is part of the marine and offshore fastening catalogue. Identify the relevant equipment and assembly position in your inquiry, then confirm the dimensions and mating components from the drawing. The application category alone does not specify a corrosion-test duration, service life or marine certification.

Marine equipment

Design basis

The product record cites DIN 6916. Include that standard designation and the relevant drawing revision in your inquiry, and identify any order-specific differences. The standard reference does not replace the need to confirm the listed size, required grade and finish. Requirements not stated in this product record should remain subject to drawing confirmation.

Drawing and part reference

Seating geometry

Confirm the hole diameter, outside diameter, thickness and seating profile from the drawing. Specify whether the requirement is for a flat or conical component, and identify its mating nut, bolt or supporting surface. Photographs illustrate the product type but do not establish washer dimensions, spring force or assembly compatibility.

Configuration to confirm

Finish & assembly conditions

The listed treatment is Black oxide. Specify which listed option is required, together with any drawing-defined preparation or inspection requirements. The recorded friction requirement should remain linked to that specification; it is not an installation-torque value. Tightening instructions and acceptance conditions need confirmation for the actual assembly.

Project-specific requirements

Selection guide.

A clear drawing and complete inquiry help distinguish the exact part from another fastener in the same application group.

  • Part reference

    Send the drawing number and revision, or identify the existing component.

  • Dimensions

    Hole diameter, thickness and seating profile. Mark any special geometry on the drawing.

  • Grade / hardness

    Identify the required listed option and retain its original grade or hardness notation.

  • Surface requirements

    State the required finish and any project-specific friction or inspection requirements.

  • Order scope

    Specify quantity, additional components and your requested delivery date.

Quote catalogue reference CF-MO-005 when contacting us. Related products below are separate catalogue entries, not a pre-approved assembly kit. Please confirm mating parts and final requirements against the assembly drawing.

Discuss your drawing

Start a Project

Bring us the drawing, specification or operating problem.

Share the application, quantity, material, grade, finish, drawing and delivery target. We will use those details to frame the next technical conversation.

RFQ