Reference photograph from the supplied product record. Confirm exact dimensions against the drawing.
Mining Machinery
Long Stud.
Drawing · 8 or 10 · M90 × 8000
Long Stud for mining machinery. Review the product reference, recorded specifications and drawing requirements to identify the configuration needed for your assembly.
Catalogue reference: CF-MI-001-R063
Parameters
Technical parameters.
| Product | Long Stud |
|---|---|
| Standard / drawing | Drawing |
| Grade / hardness | 8 or 10 |
| Size / designation | M90 × 8000 |
| Surface treatment | Black oxide |
| Friction coefficient (µ total) | Not specified in this product record |
| Application | Mining machinery |
| Application record | Pending confirmation (conflicting source years) |
Confirm the final specification against the order drawing. A recorded application year is not a service-life or warranty statement.
- The source grade is written as 8 or 10; it has not been converted to 8.8 or 10.9.
- The source lists two different record years (2013 and 2015); the year remains unconfirmed.
Product details
Product description.
Fasteners for mining equipment.
This product belongs to the mining machinery catalogue. Keep its individual part reference linked to the relevant equipment drawing when planning a replacement or a new assembly. The recorded product designation and thread system should be checked before comparing it with another mining fastener.
Design basis
This is a drawing-defined or non-standard configuration. Start with the product name and catalogue reference, then provide the current drawing revision and the exact version required. The parameter table records the supplied specification; dimensions, material designation and acceptance requirements that are not stated there should be confirmed before quotation.
Drawing and part referenceThreaded ends & length
Provide the overall length, thread designation and required threaded length at each end, together with any plain-shank or shoulder dimensions. If the catalogue uses L, specify the actual length in the drawing. Keep each stud reference separate even when several entries share the same listed diameter range and grade options.
Configuration to confirmFinish & assembly conditions
The listed treatment is Black oxide. Specify which listed option is required, together with any drawing-defined preparation or inspection requirements. No total friction-coefficient value is specified in this individual record. Confirm that requirement separately if it is needed for your assembly, together with the applicable installation and inspection instructions.
Project-specific requirementsSelection guide.
A clear drawing and complete inquiry help distinguish the exact part from another fastener in the same application group.
Part reference
Send the drawing number and revision, or identify the existing component.
Dimensions
Thread, pitch, length and mating dimensions. Mark any special geometry on the drawing.
Grade / hardness
Identify the required listed option and retain its original grade or hardness notation.
Surface requirements
State the required finish and any project-specific friction or inspection requirements.
Order scope
Specify quantity, additional components and your requested delivery date.
Quote catalogue reference CF-MI-001-R063 when contacting us. Related products below are separate catalogue entries, not a pre-approved assembly kit. Please confirm mating parts and final requirements against the assembly drawing.
Discuss your drawing



